I currently have a sort of makeshift queue system which pushes the most recent request to my printer of choice (Munbyn ITPP047), however I find that after each cut(), the printer takes around 4 seconds or so before proceeding with the next one, whereas ideally we'd be looking at around the 1 second mark, or even immediate after if possible,
I'm unable to find any limitations with the printer software itself so wasn't sure if this is within the module, or even pyusb itself, and perhaps there may be a solution or perhaps a workaround to get this delay taken care of.
I currently have a sort of makeshift queue system which pushes the most recent request to my printer of choice (Munbyn ITPP047), however I find that after each cut(), the printer takes around 4 seconds or so before proceeding with the next one, whereas ideally we'd be looking at around the 1 second mark, or even immediate after if possible,
I'm unable to find any limitations with the printer software itself so wasn't sure if this is within the module, or even pyusb itself, and perhaps there may be a solution or perhaps a workaround to get this delay taken care of.