Skip to content

Revise device opening instructions for hama 176573 smart plug #2005

New issue

Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.

Sign up for GitHub

By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.

Already on GitHub? Sign in to your account

Open
thomiel wants to merge 1 commit into
base: master
Choose a base branch
from
+1 −1
Open

Revise device opening instructions for hama 176573 smart plug #2005

Changes from all commits
Commits
Show all changes
1 commit
Select commit
File filter

Filter by extension

Filter by extension
Conversations
Failed to load comments.
Loading
Jump to
Jump to file
Failed to load files.
Loading
Diff view
Diff view
2 changes: 1 addition & 1 deletion _templates/hama_00176573
View file
Open in desktop
Original file line number Diff line number Diff line change
Expand Up @@ -14,4 +14,4 @@ type: Plug
standard: eu
chip: TYWE2S
---
The decive is hard to open - no screws - case is glued. After opening the case main PCB requires first to unsolder the two female power pins. Remove the main PCB and you get access to the TYWE2S WiFi Module. Solder 4 wires (Vcc, GND, Rx, Tx) to the board, put GPIO 0 on TYWE2S to GND, and apply 3.3 V power for flashing.
The decive is nearly impossible to open without major calamities - no screws - case is glued. Best appoach may be to sewer the case 7 mm from the underside, that's 1 mm below the switch. Don't cut deeper than 2 mm as electonic components live near the edge of the PCB. After opening the case main PCB requires first to unsolder the two female power pins. Remove the main PCB and you get access to the TYWE2S WiFi Module. Solder 4 wires (Vcc, GND, Rx, Tx) to the board, put GPIO 0 on TYWE2S to GND, and apply 3.3 V power for flashing.